Race Spec® Holley Dominator ECU Starter Harness

Introducing the Race Spec® Holley Dominator Starter Harness

This harness is the highest quality starting point for your Holley Dominator project. We have taken all details into consideration and the harness is built with a  pre-placement of idents in specific sequences to 'equal' the color combinations based on the original source connector and pin position for easy assembly.

Featuring

• Raychem Spec 55 wire and cable, solder sleeves, and splices
  
• Shielded cable for Cam, Crank, Knock 1 &2, Wideband 1 & 2
• Twisted pair for CAN 1 & CAN 2
• Twisted pair for Wideband 1 & Wideband 2 heater circuit
• Fully populated inputs and outputs
• Pre-populated splices for 0V, 5V
  
• Pre-populated splices for Injector 12V, Ignition 12V, Fuel Pump 12V, Engine Spare, Chassis Spare
  
• ECU terminations are crimped with our Schleuniger Crimp Press and genuine TE terminals
• Genuine connectors and components
• 10ft flying lead on all circuits.
• Includes J1A, J1B, J2A, J2B, J3, J4, Main Power Harness w/ Fuse, Relay & Fuse Pack for Injector & Fuel Pump 12V and Ignition & Spare 12V.

Wiring an ECU properly is a complicated task and can easily go sideways. Inferior material, poor build practices, improper tooling, and the desire to get right into things will most often lead to a poor outcome.

This product was created to eliminate the uncertainty of undertaking this massive task while knowing you are using the finest material from a world renowned harness manufacturer.

Includes

• Detailed Point-to-Point Documentation
  
• Ident Guide for Color Code Interpretation

Disclosure

This is a DIY Product and requires both common automotive electrical knowledge and experience with aftermarket engine management systems.

Not there just yet? Take a look at the courses offered by High Performance Academy and gain the knowledge and confidence you need to take your project on!