MoTeC USA M150 H10 Starter Harness

This harness is the highest quality starting point for your MoTeC M150 project. 

Featuring

• Color coded M22759/32 wire and cable, solder sleeves, and splices
  
• Shielded cable for Ref, Sync, Knock 1 & Knock 2
• Twisted pair for CAN 1, CAN 2, CAN 3
  
• Fully populated inputs and outputs
• Pre-populated splices for 0V, 5V to support all available sensors
  
• Pre-populated splices for GND and 12V to support all available injectors, coils, and half bridges
  
• Genuine connectors and components
• 10ft flying lead on all circuits
  

Wiring an ECU properly is a complicated task and can easily go sideways. Inferior material, poor build practices, improper tooling, and the desire to get right into things will most often lead to a poor outcome.

This product was created to eliminate the uncertainty of undertaking this massive task while knowing you are using the finest material from a world renowned harness manufacturer.

Includes

• Detailed Point-to-Point Documentation
  
• Ident Guide for Color Code Interpretation

Disclosure

This is a DIY Product and requires both common automotive electrical knowledge and experience with aftermarket engine management systems.

Not there just yet? Take a look at the courses offered by High Performance Academy and gain the knowledge and confidence you need to take your project on!