This harness is the highest quality starting point for your MoTeC M150 project.

Featuring

Color coded M22759/32 wire and cable, solder sleeves, and splices
Shielded cable for Ref, Sync, Knock 1 & Knock 2
Twisted pair for CAN 1, CAN 2, CAN 3
Fully populated inputs and outputs
Pre-populated splices for 0V, 5V to support all available sensors
Pre-populated splices for GND and 12V to support all available injectors, coils, and half bridges
Genuine connectors and components
10ft flying lead on all circuits

Wiring an ECU properly is a complicated task and can easily go sideways. Inferior material, poor build practices, improper tooling, and the desire to get right into things will most often lead to a poor outcome.

This product was created to eliminate the uncertainty of undertaking this massive task while knowing you are using the finest material from a world renowned harness manufacturer.

Includes

Detailed Point-to-Point Documentation
Ident Guide for Color Code Interpretation

Disclosure

This is a DIY Product and requires both common automotive electrical knowledge and experience with aftermarket engine management systems.

Not there just yet? Take a look at the courses offered by High Performance Academy and gain the knowledge and confidence you need to take your project on!

https://hpcdmy.co/RSMW

And, you can even enjoy the following discounts to get you going!

50% OFF Any Course

Code At Checkout: RACESPEC50

$300 OFF The VIP Package

Code At Checkout: RACESPECVIP

RaceGrade Flush Mount Bezel for MoTeC C125 Dash

Related Items

Make An Offer

RaceGrade Flush Mount Bezel for MoTeC C125 Dash

$ 145.00

RaceGrade Flush Mount Bezel for MoTeC C125 Dash

Precision machined flush mount bezel for the MoTeC C125 display, includes hardware.

SKU: C125 Flush Mount

$ 145.00